16Ports G.fast DPU DSLAM
The emergence of OTT videos and 4K TV is accelerating ultra-broadband network deployments. Fiber to the home (FTTH) is a good solution to offer ultra-broadband service, but is costly and difficult to deploy services due to complicated construction works.
G.fast DPU DSLAM, which reuses existing copper resources to reach speeds comparable to FTTH (1,000 Mbit/s), is well-suited to brownfield areas. Featuring faster access, faster deployment, and faster return on investment, G.fast is attracting increasing industry attention.
The service sets for DPU 3016 are IPTV, HSIA, and VoIP. Together with advanced Ethernet OAM, it also targets for business services for copper wired Multi-tenant Units.
As following block diagram, DPU 3016 supports switch selectable (1) 2.5G SFP interface and (2) 1G SFP or GE interface as its uplink interface.
Features
Profile 106a, spectrum up to 106 MHz bandwidth at 4dBm transmit power
16-port vectoring (crosstalk cancellation) with linear precoding now, and will support nonlinear precoding in the future when standards are clearly defined
Programmable Time-Division Duplexing, to accommodate different asymmetry ratios of downstream/upstream (Downstream MDS 15~29).
Full start up sequence takes less than 20sec, and the fast retrain time, including 16-port vectoring, is under 2sec.
Tolerant of inside wire impairments and changing noise conditions
Fast On-Line Reconfiguration (SRA, FRA, and bit-swapping) to cope with Channel/DPU 3016 series management structure
Follows BBF G.fast recommendations and TR-167, the DPU and G.fast SFP modem are treated as a GPON fed remote DSLAM
Currently supports CLI/WEB/SNMP management, and will add the Netconf protocol and Yang data modeling for G.997.2.
The GPON feed/GPON SFP ONT are managed by OMCI messages from the OLT.
DPU 3016 supports Ethernet OAM to provide SLAs for business users. Ethernet Service Assurance features, based on MEF, IETF, ITU, and IEEE standards enable service providers to offer businesses an assured MEF service with tools to ensure conformance to a service level agreement (SLA).
Finally, ZISA EMS can acts as NETCONF PMA to remotely manage and monitor the DPU 3016. It can help the ISP to offer the best quality service to their customers.
As following figure, please see the protocol stack supported by the EMS & DPU
Specifications
|
System Features |
Protocols Support | |
|
l G.fast Ports ü 16-port G.FAST subscriber interface Comply with ITU-T G.9700/9701,106a Profiles ü Total rate up to 800 Mbps, aggregate the downstream and upstream rate ü Support resynchronization ü Support RFI configuration ü Support G.FAST profile setup ü 16-port vectoring(crosstalk cancellation) with linear precoding ü Programmable Time-Division Duplexing, to accommodate different asymmetry ratios of downstream/upstream (Downstream MDS 15~29) ü Full start up sequence takes less than 20sec, and the fast retrain time, including 16 ports vectoring, is under 2sec. ü Tolerant of inside wire impairments and changing noise conditions ü Support Fast On-Line Reconfiguration (FRA) to cope with Channel l Bridging Port ü Tagged/Untagged/TLS port ü VLAN Ingress Filter check ü Port-based VLAN ü Protocol-based VLAN ü Priority VLAN ü S-tag/C-tag Priority Mapping ü VLAN Translation l VLAN ü Single or Double tag support ü N:1 /1:1 VLAN l Forwarding Data Base ü 4K entries of MAC address ü Dynamic/Static FDB ü MAC learning limitation per port l Multicast ü IGMP v1, v2, V3 ü IGMP proxy ü Multicast VLAN mapping u Independent VLAN multicast (IVM).
|
l IGMPv1, v2, v3 snooping and proxy l DHCP L2 Relay – TR101 Appendix B l IEEE 802.1x l STP(802.1D) / RSTP (802.1W) l SNTP Client l SysLog Client | |
|
Uplink ports | ||
|
Switch selectable l 2.5G SFP interface l 1G SFP interface | ||
|
Management | ||
|
l Local RS-232 CLI and Ethernet Web/SNMP/TELNET management l Remote in-band Web/SNMP/TELNET management l NETCONF/YANG G.997.2 Data Model * l Firmware upgradeable l Support SNMP v1, v2. l Alarm Relay for 4 input | ||
|
Operating Requirements | ||
|
l Operating Temperature: 0° to 65 °C l Storage Temperature: -40c° to 80 °C l Operating Humidity: 5% to 95% RH non-condensing | ||
|
Dimension and Weight | ||
|
l Dimension: 66mmx440mmx230mm l Weight: 4.0 kg | ||
|
Selective Power Source | ||
|
l From DSL loop 36V~57V, (Reverse power)* l AC power mode: 90VAC ~ 264 VAC, 50-60 Hz, 12V output, 6A (local power) l Power Consumption: all 16-ports up needs 75 Watts(25℃) l Power saving mode* | ||
|
Certifications | ||
|
l EMC FCC Part 15 Class A CE-EMC Class A l Safety EN60950-1 ITU-T K.21 Surge and Lightning protection |
